Initial Seedcalc Data Meeting Notes

Owned by Mikah Pinegar
Last updated: Mar 22, 2024
1 min read

  1. Updates from Kevin for Victoria

  2. What should be inputted and not pulled from airtable

    1. Location info

    2. Seed tag info

  3. MCCC vs NECCC differences

    1. Percent of single species rate should say if it’s from NECCC / MCCC

    2. Logo should change based on council

    3. State and county is for MCCC only, zones for NECCC

    4. Check for NRCS 340 standards is only MCCC

      1. Check boxes at the end should only show if that is selected

    5. MCCC ignores soil fertility NECCC has kept it

    6. Cost share is for MCCC only

    7. Seeding rate slider is only for MCCC

    8. MCCC only does single species

    9. MCCC only does Indiana

  4. Miro board goes over a lot of the differences https://miro.com/app/board/o9J_l7GWMuw=/

  5. Use seeding rate calculator tables for the process logic NECCC

    1. Default mix making (step 1)

    2. Planting and termination modifiers (step 2)

    3. Bulk seed (step 3)

  6. Use seeding rate calculator tables for the process logic MCCC

    1. Depends on whether cost share was chosen, one table for each

    2. The compare table shows the output of cost share vs no cost share

    3. The eqip check tables show nrcs cost share 340 approval (renamed bottom 4 tables to not include check)

  7. Data verification for MCCC and NECC is complete

  8. Crops are consistent between selector and seedcalc for NECCC, missing some crops for MCCC seedcalc

  9. Don't make MCCC tool public until MCCC approves

  10. Flow will be

    1. Choose state from list of states that have data

    2. See page with council’s logo etc

    3. Input info about drainage etc

    4. Continue showing logos for which council is selected after initial screen

  11. Visual changes from what’s in Figma are fine